An Object-Based Shale Permeability Model: Non-Darcy Gas Flow,Sorption, and Surface Diffusion Effects

Shale samples consist of two major components: organic matter (OM) and inorganic mineral component (iOM). Each component has its distinct pore network topology and morphology, which necessitates generating a model capable of distinguishing the two media. We constructed an object-based model using the OM and iOM composition of shale samples. In the model, we integrated information such as OM population and size distribution, as well as its associated pore-size distribution. For the iOM part, we used mineralogy and pore-size information derived from X-ray diffraction, scanning electron microscopy, and nitrogen sorption measurements. Our proposed model results in millimeter-scale 2D realizations of shale samples by honoring OM and mineral types, their compositions, shapes, and size distributions. The model can capture heterogeneities smaller than 1 mm. We studied the effects of different gas flow processes and found that Knudsen diffusion and gas slippage dominate the flow, but surface diffusion has little impact on total gas flow.     

Study of Solvability of a Thermoviscoelastic Model Describing the Motion of Weakly Concentrated Water Solutions of Polymers

We study the problem of existence of a weak solution to the initial-boundary value thermoviscoelasticity problem for the model describing the motion of weakly concentrated water solutions of polymers.     

Dynamical analysis and multistability in autonomous hyperchaotic oscillator with experimental verification

Nonlinear Dynamics - In this contribution, a modified oscillator of Tamasevicius et al. (Electron Lett 33:542–544, 1997) (referred to as the mTCMNL oscillator hereafter) is introduced with...     

X-ray diffraction study of mesogenic 4-methoxyphenyl-4′-n-nonyloxybenzoate

4-methoxyphenyl-4′-n-nonyloxybenzoate have been investigated by single crystal X-ray structural analysis. Crystal packing of the compounds does not represent a precursor of the mesophse although the typical for liquid crystal compounds separation of crystal packing on aromatic and aliphatic areas is observed here. Possible reason for monotropic properties are discussed.     

Anisotropic Elastic-Viscoplastic Properties at Finite Strains of Injection-Moulded Low-Density Polyethylene

Injection-moulding is one of the most common manufacturing processes used for polymers. In many applications, the mechanical properties of the product is of great importance. Injection-moulding of thin-walled polymer products tends to leave the polymer structure in a state where the mechanical properties are anisotropic, due to alignment of polymer chains along the melt flow direction. The anisotropic elastic-viscoplastic properties of low-density polyethylene, that has undergone an injection-moulding process, are therefore examined in the present work. Test specimens were punched out from injection-moulded plates and tested in uniaxial tension. Three in-plane material directions were investigated. Because of the small thickness of the plates, only the in-plane properties could be determined. Tensile tests with both monotonic and cyclic loading were performed, and the local strains on the surface of the test specimens were measured using image analysis. True stress vs. true strain diagrams were constructed, and the material response was evaluated using an elastic-viscoplasticity law. The components of the anisotropic compliance matrix were determined together with the direction-specific plastic hardening parameters.     

Comment on the paper “Hydromagnetic thin film flow of Casson fluid in non-Darcy porous medium with Joule dissipation and Navier's partial slip”

The present comment concerns some doubtful results included in the above paper.